Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 ◄Example►                                   ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     Command: Redirect CodeView Input and Output
 
     Syntax:  = device
 
     Argument:
 
     <device>   Device to redirect input and output to. Specify con for
                the CodeView Command window.
 
     Description:
 
     The Redirect Input and Output (=) command causes the CodeView
     debugger to read all subsequent command input from the device and
     write all subsequent output to the device. You cannot redirect
     both input and output to a file.
 
     To reset the input and output for CodeView after you have entered
     one of the other redirection commands, use the command
 
          = con
 
     See: ◄Redirect CodeView Output (>) Command-Window Command►
          ◄Redirect CodeView Input (<) Command-Window Command►
                                    -♦-