Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 
     File is read-only. Invoke: "<command>"?
 
     A request was made to save a file that is marked read-only on
     disk. The Readonly switch is set to <command>, and PWB is
     prompting for confirmation to run the command.
 
     Response    Action
 
     Y (yes)     Run <command>.
     N (no)      Do not run <command> and prompt for a new filename.
     «cancel    »Do not run <command> or prompt for a new name. This
                 cancels the save and returns you to normal editing.
                                    -♦-