Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 ◄Description► ◄Example► ◄Notes►             ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     Command: Thread (~)
 
     Syntax:  ~[specifier[command]]
 
     Summary: Displays status of threads or carries out CodeView
              commands for particular threads.
 
     Arguments:
 
     <specifier>   One of the following values, which specifies the
                   thread affected by the command:
 
                   Specifier     Thread
 
                   #             Last executed thread
                   *             All threads
                   .             Current thread
                   <number>      Thread <number>
 
                   If omitted, you cannot enter a <command>, and the
                   Thread (~) command gives the status of all threads.
 
     <command>     Command applied to the selected thread. The <command>
                   may be Breakpoint Set (~BP), Animate (~E), Freeze (~F),
                   Go (~G), Program Step (~P), Select (~S), Trace (~T),
                   or Unfreeze (~U).
 
     See: ◄Thread Breakpoint Set (~BP)►
          ◄Thread Animate (~E)►
          ◄Thread Freeze (~F)►
          ◄Thread Go (~G)►
          ◄Thread Program Step (~P)►
          ◄Thread Select (~S)►
          ◄Thread Trace (~T)►
          ◄Thread Unfreeze (~U)►
          ◄Run Menu: Thread Command►
                                    -♦-