Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 ◄Summary► ◄Description► ◄Notes►             ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
          004>~
 
     The example above displays the status of all threads, including
     their corresponding numbers.
 
          004>~2
 
     The example above displays the status of thread 2.
 
          004>~5S
 
     The example above selects thread 5 as the current thread. Since
     the current thread is 4 (a fact apparent from the CodeView
     prompt), the current thread is changing. Therefore, you can expect
     all registers and code displayed to change.
 
          005>~3BP .64
 
     The example above sets a breakpoint at source line 64, an action
     that stops program execution only when thread 3 executes to this
     line.
 
          005>~1F
 
     The example above freezes thread 1.
 
          005>~*U
 
     The example above unfreezes all threads; any threads that were
     frozen before will now be free to execute whenever the Go
     command is given. If no threads are frozen, this command has no
     effect.
 
          005>~2E
 
     The example above selects thread 2 as the current thread, then
     proceeds to execute thread 2 in slow motion.
 
          002>~3S
          003>~.F
          003>~#S
          002>
 
     The example above selects thread 3 as the current thread, freezes
     the current thread (thread 3), and switches back to thread 2.
     After switching to thread 3, no code was executed; therefore, the
     debugger considers the # symbol to refer to thread 2, the last
     thread executed.
                                    -♦-